No hay artículos en el carro
No hay artículos en el carroAIR FILTER
Customer
Comentado en Canadá el 2 de marzo de 2025
Repeat purchase
yousef z
Comentado en Arabia Saudita el 28 de mayo de 2024
It looks good
Chan
Comentado en los Estados Unidos el 14 de septiembre de 2024
For 3 years now I only use their filters on my cars both on in cabin and engine and they work great. Highly recommend them
My two cents
Comentado en los Estados Unidos el 27 de mayo de 2022
I bought this for my 2009 Toyota Sienna. It fits perfectly and the quality seems okay. The following are my instructions for a 2009 Sienna in case you've never replaced the filter before. Even if you do not have a Sienna I would still advise you to read my instructions as the latter part will still apply no matter what make and model auto you have.You'll need a 10mm socket attached to either a drive spinner, extension rod or something similar in order to loosen the two bolts located on the right side of the housing with one in front and the other on the back side. My 6-inch drive spinner was a perfect size to get to the bolt on the back side. Notice I said loosen as they do not need removed. Also, you'll need to disconnect a few air hoses on the left side of the housing in order to lift the housing away enough to pull out the old filter and put in the new one. TAKE NOTE, if you lift the housing too much it will cause the two connection points on the left side to disengage and you'll wonder why you cannot replace the housing to its original tight seal when you put it back together. It’s no big deal if you do. Just angle the left side of the upper housing downward enough so the two connection points on it can slip under the opposing connection points on the bottom housing (see picture).Now the MOST IMPORTANT THING: the filter has a top and bottom and a front and back. Please look at the attached pictures. You can see the old filter with the printing on it to guide you unlike the replacement filter. The easiest way for you to know which side and direction is correct is to look at all four corners of the filter. Only one of the corners comes to a sharper point than the other three. That corner belongs to the front right. Once you've got that right and put it in place then, of course, it's just a matter of putting it all back together. Again, remember what I said earlier about the connection points on the left side of the housing.I hope my instructions save someone a little time, effort and headache.
Nassar AbdulAziz Nassar
It suppose to fit 2010 camrey, but the one i received is bigger than old one, it did not fit in my car.
Productos recomendados
Mex $370.84
Mex $ 203 .00 Mex $203.00
Mex $8,594.09
Mex $ 1,881 .00 Mex $1,881.00
Mex $397.73
Mex $ 182 .00 Mex $182.00
Mex $299.00
Mex $ 152 .00 Mex $152.00
Mex $153.16
Mex $ 78 .00 Mex $78.00