No hay artículos en el carro
No hay artículos en el carroChava
Comentado en México el 28 de febrero de 2025
Funciona bien pero los cables no van como lo describe el manual
Maxxram
Comentado en los Estados Unidos el 23 de febrero de 2025
Great fit and easy to install. Will require additional wiring to work properly. For those of you that think this willl be plug and play it is not. The wires terminate in bare ends. Install both lights. The left light is the one with the larger wire harness. On the right one you will need to cut and extend the red wire to correct the issue of both lights blinking with the turn signal on. Run the main harness down through the tub to the left tail light and make your connections. On the right side extend your red wire only down to the right side tail light and tap into the right side turn signal wire. After doing this they will work perfectly.
Anthony Snyder
Comentado en los Estados Unidos el 20 de abril de 2025
Love them, that's why I ordered a second set for my other jeep
Manuel
Comentado en los Estados Unidos el 1 de diciembre de 2024
No se pudo cargar el contenido.
Brian Quinn
Comentado en los Estados Unidos el 1 de julio de 2023
GOOD: The LED lights themselves are fantastic, the housing, the fit (they click right on). The wiring harness is great and can make it down into the tire well (where the wiring is) if your able to run it through the hard top with the rear wiper/washer lines...BAD: As far as connections: this is NOT plug and play, you have to splice these into the wiring yourself, which is fine if you're ok doing that type of work...UGLY: the 'turn signals' don't actually work properly. they both flash together with whichever side harness you splice them into... this is a serious problem and a major design flaw... since the stock lights use the running lights as a turn signal in DOT vehicles, each sides turn signal/running light is different.You can fix the turn signal issue, if you know what your doing, and want to wire a 5th wire down the harness and run the entire harness into the drivers side. in that wheel well there is the wiring harness for the trailer lights (if you have the trailer package...) you can then splice the proper 5th wire for the passenger side into that wire, and then they would function as proper turn signals... but you should probably know what your doing for that.... so good luck...
Leonardo
Great product & good value for money. Functional & added more visibility at night. Highly recommended.
Productos recomendados