No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Soporte de motor de aluminio sólido y duradero
El total está hecho de aluminio, la base está hecha de plástico. Clasificación de HP: 7-1/2 a 20, tamaño amplio: 8 x 10-1/5 pulgadas. Tamaño de montaje: 5-1/4 pulgadas x 9 pulgadas, el peso máximo es de 52 kg. Soporte ajustable cargado por resorte (5 posiciones verticales), cuerpo de pista ancha para mayor estabilidad. Tablero de montaje de polipropileno sólido. El resorte pesado fácil de levantar ayuda a equilibrar el peso del motor. Perfecto para lanchas de motor y yates de tamaño pequeño a mediano.
NC Basser
Comentado en los Estados Unidos el 29 de diciembre de 2024
Very sturdy mount. Easy to install. Worked great for my 6.5HP kicker motor.
Daniel B.
Comentado en los Estados Unidos el 28 de diciembre de 2024
Worked great for my kicker motor .
J. Mark Malsom
Comentado en los Estados Unidos el 1 de octubre de 2024
This bracket is very sturdy. I have my 6 hp 57 lb. trolling motor hung on it. The bracket that attaches to the transom is 3/16" . The lifting/lowering mechanism is 3/8". I installed it by myself, but would have been nice to have a second set of hands when marking the position to drill on the transom. I measured the length of my motor shaft. I lowered the bracket to it's lowest position and attached a yardstick to the top of where the motor attaches to the bracket, marking the length of the shaft on the yardstick. I then lowered it to the position where the shaft length (at the cavitation plate) is even with the bottom of the hull. Marked the hole positions and drilled 5/16" holes to accommodate the carriage bolts, which were provided, but I had to get longer ones. When installing remember to use backing plates on the inside of the transom to distribute the load. No mounting instructions are included. If needed you can find instructions on the internet for other brands. They are all basically the same.
Kindle Customer
Comentado en los Estados Unidos el 22 de septiembre de 2024
Solid, well made bracket for my kicker. Virtually identical to Panther for half the price.
DOUGLAS P
Comentado en los Estados Unidos el 7 de agosto de 2023
The motor bracket has a long reach. It was used on a 24’ sailboat. A 2-1/2 hp Suzuki motor was mounted. One difficulty was rotating the motor up, the motor housing hit the handle and would not lock in place. I had to tie the motor up when rotated out of the water. This may be unique to the Suzuki motor. Another difficult was raising the motor from the fully down position. It was very difficult to disengage the locking lever. The motor needed to be pushed down a bit further to disengage the lever.
Productos recomendados
Mex $1,649.93
Mex $ 692 .00 Mex $692.00
Mex $2,475.17
Mex $ 1,163 .00 Mex $1,163.00
Mex $2,492.61
Mex $ 1,146 .00 Mex $1,146.00
Mex $431.37
Mex $ 228 .00 Mex $228.00