No hay artículos en el carro
No hay artículos en el carroMitchell Family
Comentado en los Estados Unidos el 4 de marzo de 2025
Works great
Coyotecreekfarm
Comentado en Canadá el 16 de agosto de 2024
Works great , and is easy to install. It took a bit of working with to get it reading properly, but now works a little to good. When it shows empty it's empty and I had to walk back to the house
lamarre
Comentado en Canadá el 6 de septiembre de 2024
bon produit
Ranger
Comentado en los Estados Unidos el 2 de septiembre de 2024
I put this fuel sensor and new gauge in my 77 boat and everything works good, no more worries
kelly hayden
Comentado en los Estados Unidos el 12 de noviembre de 2020
I installed this in my John Deere F932 lawn mower. JD wanted $150 for a factory one and used ones were around $90 online. The installation instructions for setting the resistance range were fairy easy to follow. I used my multimeter to measure the resistance range of my sending unit when empty and full (about 8 and 184 ohms in my case). So I selected the 10-180 ohm range. You press and hold the mode button for 3 seconds or so to put it into setup mode. The backlight will begin to flash. Then you press and release the mode button as needed until the needle points to the fill mark on the gauge that corresponds to the ohms range as illustrated in the instructions. In my case I had to press and release a couple times until the needle point to the half full mark, which corresponds to 10-180 ohms. Once set, power down the unit and you are done. It has like 6 different back light colors you can set as well, but I didn't mess with it. I left it the default red.
Productos recomendados