No hay artículos en el carro
No hay artículos en el carroDescripción del producto
El disipador de calor M.2 combina refrigeración activa y pasiva, la temperatura se reduce y garantiza un rendimiento duradero
[Mejor sistema de refrigeración]
3 tubos de calor de cobre de 4,5 mm, proporcionando una excelente disipación de calor, disipando rápidamente el calor transferido por el tubo de cobre.
Ventilador de refrigeración PWM más grande de 40 mm
Con ventilador de enfriamiento PWM silencioso de 40 mm más grande. Bajo nivel de ruido a una velocidad máxima de 8500 RPM enfría rápidamente su SSD.
Nota de compatibilidad:
Compatible solo con SSD M.2 NVMe 2280 de una sola cara/doble cara. !
No compatible con memoria 2230,2242, 2260.
Tubo de calor de cobre
3 tubos de calor de cobre de 4,5 mm, proporcionando eficazmente una excelente disipación del calor.
Puede disipar rápidamente el calor transferido por el tubo de cobre.
Ventilador de refrigeración PWM 40MM
Ventilador potente de 9 aspas de 40 x 40 mm, 8500 rpm, bajo ruido y sin vibraciones.
Bajo nivel de ruido a una velocidad máxima de 8600 RPM enfría rápidamente su SSD.
Fácil de instalar
Tecnología de base Direct-Touch---Fácil instalación
Aletas de aluminio de alta densidad
Combinado con ventilador de refrigeración y aletas de aluminio para lograr un mejor rendimiento de disipación de calor.
Matthew Abbott
Comentado en los Estados Unidos el 23 de mayo de 2024
Overall very happy with this purchase for a gen 5 SSD that was having heat problems under sustained writes as well as during GPU load. This has kept the drive in the 50-60C range throughout both scenarios even with a very minimal fan speed curve applied. I appreciate that the bottom bracket is also metal, which ought to perform much better for double-sided SSDs than the plastic brackets I see in competing products.I installed this unit in the M.2 slot between my CPU and first PCIe slot, which holds my GPU. I was a little concerned the GPU might encroach on this space enough to prevent installation but there was plenty of room. The fan cable had plenty of length to reach the fan header at the rear edge of the motherboard. I think it would have a hard time reaching headers at the south edge of the board, and it's definitely worthwhile to pay attention to which side you want the cable facing after installation so that you can mount the top piece in the appropriate direction.The only issue I had was during assembly. I opted to use Arctic TP-3 1mm thermal pads to have a known quantity. This appears to be the same thickness as the included pad, and the latter is stiffer and harder to deform so I believe the experience would be the same anyway. I applied a layer of pad to both the top spreader and the bottom bracket before assembling around the SSD. While the first screw hole was easy to align with the bracket's slot, it was difficult to apply enough pressure to align the next screw hole (diagonally across) enough to insert the screw without marring the area around the hole a bit. I know the dimensional requirements make side-mount screws a necessity, but by the end I was really wishing I could get the clamping behavior that would come with vertical screws.If I were buying all over again I would opt for 0.5mm thickness pads. I don't fault NewHail for any of this, especially since I didn't try their pads; I write the above just in case it helps someone. Once assembled, the bottom bracket did not hinder the SSD from making good contact with the mounting cam.Overall I'm very happy with this purchase, and I expect this to hold up just fine over time. Even if the small fan fails early, it appears that they kept it easy to swap that part out yourself. This may also come in handy if you do find the fan sound annoying.
Gabriel Dayan
Comentado en el Reino Unido el 17 de febrero de 2024
When the motherboard heatsink is inadequate, this is the solution.
Jason
Comentado en Canadá el 11 de diciembre de 2024
GOOD
Zelbouni
Comentado en Francia el 19 de febrero de 2023
parfait simple mais je trouve le prix un peux haut je recommande
Elena
Comentado en Italia el 21 de octubre de 2023
Dissipatore ottimo ne ho già altri 2 ma questo è nettamente superiore ,ho solo sostituito i pad termici con quelli dell'arctic 3, la temperatura è sui 31 gradi prima era 35/36 .lo consiglio ma vedetd prima lo spazio io ho jn dissipatore noctua e non ho potuto montarlo sulla slot 4.0 ma sulla slot 3.0 CONSIGLIATISSIMO.
Productos recomendados
Mex $348.41
Mex $ 156 .00 Mex $156.00
Mex $249.00
Mex $ 144 .00 Mex $144.00
Mex $359.90
Mex $ 176 .00 Mex $176.00